MIL-PRF-23377K TY1 CLN GREEN

Back to: Primer
PDFPrintEmail
Description

02GN083 and 02GN084 are chrome free, fast dry, chemically cured, two component, high solids, epoxy-polyamide primers for application on metallic and non-metallic substrates. Component A contains the pigment and polyamide resin. Component B is a clear non-pigmented epoxy component, which acts as a hardener or curing agent for Component A. When these epoxy primers are used over properly prepared substrates they provide a corrosion inhibiting, chemical and solvent resistant film suitable for topcoat. Films are resistant to immersion in water, jet fuels, lubricating oils and hydraulic fluids.



Item #: MIL-PRF-23377K
Rating: Not Rated Yet
Specifications
Type Type I, Class N
Color Green
Mix Ratio, by Volume 3 parts base to 1 part catalyst
Reducer IS-237 (Use only if needed and if local and state VOC limits allow)
Induction Time No Induction necessary
Recommended Dry Film Thickness 0.6 - 0.9 mils
Initial Mixed Viscosity 40 seconds max #4 Ford
Average Theoretical Weight Per Gallon, Mixed 11.1 ± 0.2
Average Theoretical % Solids By Weight, Mixed 56.8 ± 0.4
Average Theoretical % Solids By Volume, Mixed 46.8 ± 0.2
Average Theoretical Coverage at 1 mil Dry Film Thickness 751-sq ft at 100% transfer efficiency
Pot Life at 63º - 85ºF 4 hours
Coatings VOC 340 g/L, max (2.8 lb/gal)
Shelf Life

1 year when stored between 35° - 115°F in original, unopened containers, away from direct sunlight.

Dry Times at 63º - 85ºF, 0.6 - 0.9 mils

Dry to topcoat: 5 hours max

Tack free: 1.5 hours max

Dry hard: 3 hours max

May be forced dried for “dry to stack” conditions. Contact Deft Tech Support for more information.

Application Recommendations

02GN084 may be applied by conventional, airless, air assisted airless, HVLP or electrostatic spray equipment. 02GN083 to be applied by brush.

Clean Up

IS-237 Epoxy reducer

Health, Safety, Storage & Handling

Refer to the MSDS for each component.

Note

Typical Characteristics (Before Reduction)

Characteristics are calculated based on product formula and raw material characteristics reported by raw material suppliers

Values are thought to be representative, but they are not to be treated as specifications

Reviews

There are yet no reviews for this product.